Custom mechanical subassemblies must integrate cleanly with process lines and OEM equipment. Focus is uptime, maintainability and straightforward installation on site. In addition, documentation is structured so suppliers can fabricate without back-and-forth. This page summarises our industrial process equipment design scope.
Our Industrial Process Equipment
What we design
Feeders, small handling and dosing equipment.
Pump/filter/heat-exchanger skids and equipment frames.
Guards, covers, housings and acoustic enclosures.
Interfaces/adapters and retrofit kits for OEMs.
Tie-ins to surrounding structures, platforms and services.
Engineering scope
3D CAD modelling and tolerance stacks; material and surface specs.
Shaft/bearing/drive sizing where applicable; ventilation/thermal notes.
FEA for brackets, frames and fatigue-sensitive details.
DFM/DFS checks for fabrication and on-site assembly.
Safety compliance for guards and access to relevant EN/ISO standards.
Deliverables
Manufacturing pack: DWG/DXF/STEP/PDF, BOMs and spec sheets.
Clear interfaces (connection locations, loads, access and service clearances).
Vendor coordination and tidy handovers. Therefore, commissioning is faster.
Upgrades & retrofits
Swap-in frames/adapters for new OEM units.
Guarding and access improvements to current standards.
Noise reduction and maintainability upgrades.
Contact us about industrial process equipment — custom frames and skids, guards and housings, ready for production.
Leave a Request
We are passionate about technology, mechanics, machinery and mechanical design. Feel free to contact our team of professionals any time and we will be back to you as soon as possible.
1 Step 1
